Volume IX, Issue 12, Page 36

Check Out That Chassis


12/8/2007

Can you tell me when setting the engine angle in a door slammer; from where do you set the angle, at the top of the block or intake?

Ken Gokool
Trinidad, West Indies

Ken Gokool,

When setting the engine angle, we use a line-up bar thru the mains in the block and it runs back to the pinion bearings. This would be the same as using the top of the block to set angle.

Scott Weney
President, S & W Race Cars
610-948-7303X111

Ask the Experts!!

Submit your tech question to Scott Weney here.

Do you want to subscribe to our FREE email newsletter?

Your Question may or may not be chosen to be published on this page.


You can also email Scott Weney at chassis@dragracingonline.com

 

Here's What's New!